Hot Runner System AMP-D1

1. The gate is in good appearance by leaving small gate vestige on the part surface, the size of the mark is in derect relation to the diameter of gate and plastic performance. The less not hot senstive the thermoplastic, or the lager the gate diameter. The more the vestige will produce. For this reason, the gate is often sunk into a spherical depression, so that the mark does not protrude above the part surface.

2. This nozzle can be widely used, such as for major crystalline and amorphous material, which is general gating system.

3. Color change is very effective. Due to the gate is very smooth without any dead plastic.

4. The quality of this gate relies on gate diameter, gate area cooling and temperature controll at the tip, so it is not suitable for cut-sensitive material with large filling additives.